Inleiding

This guide will help you replace the logic board.

Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.
  • Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.

  • Poke out rubber covers using a spudger or pointy object, such as a thumb tack.

Voeg opmerking toe

Use a T6 torx screwdriver to unscrew the 6 screws that hold the back casing on.
  • Use a T6 torx screwdriver to unscrew the 6 screws that hold the back casing on.

Voeg opmerking toe

  • Use IPod opening tool to separate back housing.

  • There are two tabs located on either side of the phone.

Voeg opmerking toe

  • Separate the back housing from the phone.

  • Be careful not to rip out the wire (highlighted in yellow) when separating the back housing.

Voeg opmerking toe

  • Use a spudger to disconnect antenna wire.

Voeg opmerking toe

  • Use the IPod opening tool to pop out the logic board.

Voeg opmerking toe

  • Use the IPod opening tool to disconnect the main ribbon.

Voeg opmerking toe

  • Once the ribbon is detached, remove the logic board and replace if necessary.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Joshua Herrmann

Lid sinds: 16-04-10

8 Reputatie

16 handleidingen geschreven

Team

Cal Poly, Team 6-14, Maness Spring 2010 Lid van Cal Poly, Team 6-14, Maness Spring 2010

CPSU-MANESS-S10S6G14

4 Leden

16 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 1,148