Inleiding

This guide will teach you how to replace the motherboard on the LG CF360. Completing this task will allow you to replace the number pad, SIM card port, power connector, LCD connector, and camera all in one.

On the back of the phone, place your thumb on the three raised bumps and slide the back cover upward. On the back of the phone, place your thumb on the three raised bumps and slide the back cover upward.
  • On the back of the phone, place your thumb on the three raised bumps and slide the back cover upward.

Voeg opmerking toe

Lift and remove the battery.
  • Lift and remove the battery.

Voeg opmerking toe

Remove the two screw covers at the top of phone with tweezers. Remove the two screw covers at the top of phone with tweezers.
  • Remove the two screw covers at the top of phone with tweezers.

Voeg opmerking toe

Remove the six Phillips #000 (3mm) screws.
  • Remove the six Phillips #000 (3mm) screws.

Voeg opmerking toe

Use the plastic opening tool to pry the back cover off. Insert the tool between the back cover and red mid section and go around the entire phone. The plastic side buttons fall out when you take the back cover off. The back cover is connected to the speaker by red and black wires.
  • Use the plastic opening tool to pry the back cover off. Insert the tool between the back cover and red mid section and go around the entire phone.

  • The plastic side buttons fall out when you take the back cover off.

  • The back cover is connected to the speaker by red and black wires.

Voeg opmerking toe

Use the tweezers to remove the red and black wires connecting the speaker to the green motherboard by pinching the sides of the plastic base near the motherboard.
  • Use the tweezers to remove the red and black wires connecting the speaker to the green motherboard by pinching the sides of the plastic base near the motherboard.

  • Set the back cover with the speaker aside.

Voeg opmerking toe

Use the plastic opening tool to gently lift the snapped-in motherboard from the front panel. An orange ribbon from the LCD is connected to the underside of the motherboard, so do not force the motherboard from the rest of the phone yet.
  • Use the plastic opening tool to gently lift the snapped-in motherboard from the front panel.

  • An orange ribbon from the LCD is connected to the underside of the motherboard, so do not force the motherboard from the rest of the phone yet.

Voeg opmerking toe

Gently remove the blue transparent tape from the connector.
  • Gently remove the blue transparent tape from the connector.

Voeg opmerking toe

With the plastic opening tool, gently pry the LCD connector from the motherboard.
  • With the plastic opening tool, gently pry the LCD connector from the motherboard.

  • Set the motherboard aside.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

3 andere personen hebben deze handleiding voltooid.

Aaron

Lid sinds: 15-10-13

159 reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 4-27, Amido Fall 2013 Lid van Cal Poly, Team 4-27, Amido Fall 2013

CPSU-AMIDO-F13S4G27

4 Leden

16 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 2

Altijd: 756