Inleiding

Back Cover Teardown guide must be used first to get inside the camera. Later, soldering guides will be used.

Onderdelen

Geen onderdelen nodig.

Remove the two 6.2mm Phillips screws on both sides of camera's back cover. Remove the two 6.2mm Phillips screws on both sides of camera's back cover.
  • Remove the two 6.2mm Phillips screws on both sides of camera's back cover.

Voeg opmerking toe

Turn camera so the bottom is facing up and the front is facing away.
  • Turn camera so the bottom is facing up and the front is facing away.

  • Remove the two 6.2mm Phillips screws on the bottom back cover of the camera.

  • Back cover is now unscrewed an can be removed.

Voeg opmerking toe

Mac RAM Kits
Versnel je Mac. Breid zijn geheugen uit.
Mac RAM Kits
Haal meer megabytes uit je Mac.
Have the back of the camera facing up.
  • Have the back of the camera facing up.

  • Unscrew the 6.2mm Phillips screw next to the viewfinder.

  • The back cover is now unscrewed. Lift up and pull the cover off evenly.

Voeg opmerking toe

The capacitor is located at the bottom center of the camera.
  • The capacitor is located at the bottom center of the camera.

Voeg opmerking toe

Desolder the two connections at the top of the flash capacitor.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Michelle

Lid sinds: 04-04-11

86 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 25-28, Garner Spring 2011 Lid van Cal Poly, Team 25-28, Garner Spring 2011

CPSU-GARNER-S11S25G28

4 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 4

Altijd: 1,728