Inleiding
This guide will go through the process of replacing the SD Card Reader in the First Generation Amazon Kindle.
Wat je nodig hebt
-
-
-
Slide the grey plastic cover laterally off the back of the device.
Vraag FixBot
-
-
-
Use a plastic opening tool to lift the battery on the side closest to the edge of the device.
-
Unplug the battery from the device by pinching the white connector and pulling.
-
-
-
-
-
-
Start at one side of the device. Use a plastic opening tool to separate the casing of the device. Slowly work your way around the entire device.
-
-
-
Unscrew the two (2) Phillips #00 screws (3 mm) which fasten the metal casing shield.
-
Slowly remove the metal casing shield by lifting it and carefully peeling up the tape.
-
-
-
Remove the four (4) Phillips #00 screws (3 mm) which fasten the SD Card Reader.
-
-
-
Lift the flap attaching the blue and white ribbon cable to the motherboard by lifting it vertically with a spudger.
-
Carefully lift the SD Card Reader vertically from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
Annuleren: ik heb deze handleiding niet afgemaakt.
2 andere personen hebben deze handleiding voltooid.
Team
University of Kentucky Louisville, Team 1-1, Chamberlain Spring 2013 Lid van University of Kentucky Louisville, Team 1-1, Chamberlain Spring 2013
LOUISVILLE-CHAMBERLAIN-S13S1G1
2 Leden
11 handleidingen geschreven
