Inleiding

This guide will teach the reader to install a new Battery Circuit Connector into the battery case. This may need to be done if the batteries are not delivering electricity into the camera.

Onderdelen

Geen onderdelen nodig.

Flip the camera over so the bottom is facing you. Flip the camera over so the bottom is facing you.
  • Flip the camera over so the bottom is facing you.

Voeg opmerking toe

Open the cover on the bottom by sliding it in the direction of the arrow. Open the cover on the bottom by sliding it in the direction of the arrow.
  • Open the cover on the bottom by sliding it in the direction of the arrow.

Voeg opmerking toe

Remove the batteries by pulling up on the top with your fingers.
  • Remove the batteries by pulling up on the top with your fingers.

Voeg opmerking toe

Remove the three screws from the circuit connector.
  • Remove the three screws from the circuit connector.

Voeg opmerking toe

Remove the connector from the battery holder door.
  • Remove the connector from the battery holder door.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Nick Oleskowicz

Lid sinds: 03-04-12

236 reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 15-13, Forte Spring 2012 Lid van Cal Poly, Team 15-13, Forte Spring 2012

CPSU-FORTE-S12S15G13

5 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 4

Altijd: 1,303