Inleiding

This guide will show you how to replace the RAM for the purpose of upgrading it.

Ensure the laptop has been properly shut down and unplugged.
  • Ensure the laptop has been properly shut down and unplugged.

  • Turn the computer over so that you can see the battery release tab located near the top of the Thinkpad.

Voeg opmerking toe

Use your finger to slide the release tab to the unlocked symbol.
  • Use your finger to slide the release tab to the unlocked symbol.

Voeg opmerking toe

Hold the tab in the unlocked position and push the battery away from the computer to remove it. Hold the tab in the unlocked position and push the battery away from the computer to remove it. Hold the tab in the unlocked position and push the battery away from the computer to remove it.
  • Hold the tab in the unlocked position and push the battery away from the computer to remove it.

Voeg opmerking toe

Slide the new battery in until it clicks.
  • Slide the new battery in until it clicks.

  • Ensure that the release tab is in the locked position.

Voeg opmerking toe

Using a #0 Phillips screwdriver, remove four 17.0mm screws on the back of the computer.
  • Using a #0 Phillips screwdriver, remove four 17.0mm screws on the back of the computer.

    • These screws have a RAM symbol next to them.

Voeg opmerking toe

Flip back over and open the laptop.
  • Flip back over and open the laptop.

  • Lift up on the inside front panel just below the edge of the keyboard.

Voeg opmerking toe

The green rectangles under the front panel are the RAM.
  • The green rectangles under the front panel are the RAM.

Voeg opmerking toe

Press out on the two tabs on either side of the ram at the same time. The RAM will release and pop up at a 25 degree angle. The RAM will release and pop up at a 25 degree angle.
  • Press out on the two tabs on either side of the ram at the same time.

  • The RAM will release and pop up at a 25 degree angle.

Voeg opmerking toe

Pull the RAM away from the housing to remove.
  • Pull the RAM away from the housing to remove.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

8 andere personen hebben deze handleiding voltooid.

Kyle

Lid sinds: 18-04-13

261 Reputatie

8 handleidingen geschreven

Team

Cal Poly, Team 8-58, Johann Spring 2013 Lid van Cal Poly, Team 8-58, Johann Spring 2013

CPSU-JOHANN-S13S8G58

4 Leden

10 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 11

Afgelopen 7 Dagen: 33

Afgelopen 30 Dagen: 115

Altijd: 4,630