Ga door naar hoofdinhoud

Inleiding

In this guide you are going to learn how to take out the current power cord in order to replace it with a new one.

  1. Remove container from base. Hold the blender and the container, then twist the container in a clockwise motion. Make sure to follow the lock and unlock markings on the container.
    • Remove container from base.

    • Hold the blender and the container, then twist the container in a clockwise motion.

    • Make sure to follow the lock and unlock markings on the container.

  2. Turn the blender so the bottom is facing you.
    • Turn the blender so the bottom is facing you.

    • Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the base.

  3. Lift the two wires from the motor platform.
    • Lift the two wires from the motor platform.

  4. Using the wire cutters, cut the end of the thick black wires.
    • Using the wire cutters, cut the end of the thick black wires.

Conclusie

To reassemble your device, you must solder the new power cord to the thin black and thin gray wires, and follow the steps in reverse order. Requires soldering skills.

Één andere persoon heeft deze handleiding voltooid.

Andrew Huff

Lid sinds: 04-09-15

487 Reputatie

3 handleidingen geschreven

Team

USF Tampa, Team 2-5, Sullivan Fall 2015 Lid van USF Tampa, Team 2-5, Sullivan Fall 2015

USFT-SULLIVAN-F15S2G5

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 1

Afgelopen 30 dagen: 8

Altijd: 1,235