Inleiding

Replace the wireless card in your HP Pavilion dv6000.

  1. Lay the laptop on a flat surface, battery side up.
    • Lay the laptop on a flat surface, battery side up.

    • Remove the two screws securing the RAM shield to the lower case.

    • The screws will remain captive within the shield.

    • Lift and remove the RAM shield up from the lower case.

    Voeg opmerking toe

  2. Use a pair of tweezers to disconnect both antennas from their sockets on the wireless card.
    • Use a pair of tweezers to disconnect both antennas from their sockets on the wireless card.

    • Be careful to pull on the contacts and not the wires. The crimps used to hold them to the wires are delicate.

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • Remove the two 3.7 mm Phillips screws securing the wireless card to the motherboard.

    • Upon removing the Phillips screws that secures the wireless card to the motherboard, the wireless card board should pop up from its top side.

    • Grasp the wireless card and pull it straight out of its socket on the motherboard.

    Voeg opmerking toe

    • Wireless card remains.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

4 andere personen hebben deze handleiding voltooid.

Ben Hirsch

Lid sinds: 05-10-10

3.634 Reputatie

10 handleidingen geschreven

Team

Cal Poly, Team 21-33, Regan Fall 2010 Lid van Cal Poly, Team 21-33, Regan Fall 2010

CPSU-REGAN-F10S21G33

4 Leden

10 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 3

Afgelopen 30 Dagen: 54

Altijd: 25,363