Inleiding

Removing the Main Display

Onderdelen

Geen onderdelen nodig.

  1. Turn off the phone. Position the phone so that the back side is in view.
    • Turn off the phone.

    • Position the phone so that the back side is in view.

  2. Apply pressure on the cover while simultaneously sliding the cover downward.
    • Apply pressure on the cover while simultaneously sliding the cover downward.

    • Remove the back battery cover.

  3. Insert the spudger between the base of the phone and the phone battery. Position the phone so that the battery won't fall out of the phone. Carefully lift the battery out of the phone.
    • Insert the spudger between the base of the phone and the phone battery.

    • Position the phone so that the battery won't fall out of the phone.

    • Carefully lift the battery out of the phone.

      • The battery lifts out of the phone easily.

  4. Gratis verzending van alle bestellingen van meer dan US$ 100,00 of met een Pro Tech Toolkit!

    Doorblader onze winkel

    Ooit iets gerepareerd? Je bent een genie.

    Deel je reparatie met #ImAGenius

    We zijn allemaal genieën

    Deel je reparatie met #ImAGenius

  5. Keep the phone closed.
    • Keep the phone closed.

    • Hold the phones sideways with the front cover of the phone facing up.

  6. Find the slight crease on the side that divides the display assembly in half. Slowly wedge the spudger into the crease.
    • Find the slight crease on the side that divides the display assembly in half.

    • Slowly wedge the spudger into the crease.

      • It's a little difficult to perform this step because the crease is narrow. Do not rush because you may damage the phone

  7. Run the spudger all along the crease while lifting up. Separate the front cover from the front base.
    • Run the spudger all along the crease while lifting up.

    • Separate the front cover from the front base.

  8. Remove the four 5mm screws on the metal casing using the T6 Torx screwdriver. Remove the four 5mm screws on the metal casing using the T6 Torx screwdriver.
    • Remove the four 5mm screws on the metal casing using the T6 Torx screwdriver.

  9. Using the spudger, disconnect the green display cable. Using the spudger, disconnect the green display cable.
    • Using the spudger, disconnect the green display cable.

  10. Lift the metal casing. Be careful not to pull the casing too hard because it is still attached to the phone by a wire. Remove the main display from under the metal casing.
    • Lift the metal casing.

      • Be careful not to pull the casing too hard because it is still attached to the phone by a wire.

    • Remove the main display from under the metal casing.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Michael Machado

Lid sinds: 21-01-11

334 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 1-14, Amido Winter 2011 Lid van Cal Poly, Team 1-14, Amido Winter 2011

CPSU-AMIDO-W11S1G14

5 Leden

16 handleidingen geschreven

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 968