Ga door naar hoofdinhoud

Creative Ziio 7" Camera Replacement

Wat je nodig hebt

  1. Creative Ziio 7" Camera Replacement, Back Panel: stap 1, afbeelding 1 van 3 Creative Ziio 7" Camera Replacement, Back Panel: stap 1, afbeelding 2 van 3 Creative Ziio 7" Camera Replacement, Back Panel: stap 1, afbeelding 3 van 3
    • Remove the back panel by using the plastic opening tool to carefully pry around the panel's edges.

    • The volume control button and the top power button may fall out during this step.

  2. Creative Ziio 7" Camera Replacement, Camera: stap 2, afbeelding 1 van 3 Creative Ziio 7" Camera Replacement, Camera: stap 2, afbeelding 2 van 3 Creative Ziio 7" Camera Replacement, Camera: stap 2, afbeelding 3 van 3
    • Unscrew the four 3mm Phillips #00 screws found in each corner of the motherboard.

  3. Creative Ziio 7" Camera Replacement: stap 3, afbeelding 1 van 3 Creative Ziio 7" Camera Replacement: stap 3, afbeelding 2 van 3 Creative Ziio 7" Camera Replacement: stap 3, afbeelding 3 van 3
    • Unplug the ribbon cable near the edge of the motherboard in the bottom right of the device.

  4. Creative Ziio 7" Camera Replacement: stap 4, afbeelding 1 van 2 Creative Ziio 7" Camera Replacement: stap 4, afbeelding 2 van 2
    • Lift up the motherboard.

    • A mesh-like strip on the right side will be connected to the bottom of the motherboard.

    • Remove the tape on top of the strip. Use tweezers or pliers to pull on the strip and unplug it.

  5. Creative Ziio 7" Camera Replacement: stap 5, afbeelding 1 van 2 Creative Ziio 7" Camera Replacement: stap 5, afbeelding 2 van 2
    • Lift up the motherboard and locate the ribbon cable (burnt orange-colored strip) centered on top of the motherboard.

    • The ribbon cable with the attached camera is plugged into the motherboard.

    • Unplug the ribbon cable using your fingers to pull up on the flap.

  6. Creative Ziio 7" Camera Replacement: stap 6, afbeelding 1 van 2 Creative Ziio 7" Camera Replacement: stap 6, afbeelding 2 van 2
    • Use a spudger to pry the camera away from the rubber camera mount.

    • Do not remove the entire rubber camera mount. Only remove the camera attached with adhesive.

    • Remove the broken camera and use electronic-friendly adhesive to attach a new camera.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Kendall Ruggles

Lid sinds: 04/16/13

26 Reputatie

1 Handleiding geschreven

Team

Cal Poly, Team 14-10, Maness Spring 2013 Lid van Cal Poly, Team 14-10, Maness Spring 2013

CPSU-MANESS-S13S14G10

4 Leden

13 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 2

Afgelopen 30 dagen: 2

Altijd: 332