Inleiding

This guide will disassemble the fan to clean the fan blades.

Onderdelen

Geen onderdelen nodig.

Use a Philips #2 screwdriver to unscrew the four 6mm Phillips #0 back screws.
  • Use a Philips #2 screwdriver to unscrew the four 6mm Phillips #0 back screws.

  • Do this by unscrewing from left-to-right then pull the screws out of the back of the fan

Voeg opmerking toe

Pull the front and back cover apart.
  • Pull the front and back cover apart.

  • Be careful not to pull the front cover off completely because it holds the wires.

Voeg opmerking toe

  • Remove the Phillips (5-mm head) 6-mm screw that holds the circuit board to the outer shell of the fan.

  • Make sure the fan is unplugged while removing the circuit board as you may get shocked.

  • To remove the screws, unscrew in a left-to-right fashion at an angle to make sure that the wires do not get tangled.

Voeg opmerking toe

  • Remove the top cover containing the circuit board and the wires by pulling it away from the body of the fan.

Voeg opmerking toe

  • Remove the circuit board from the top cover. Do not touch the other side of the circuit board as you may damage circuit elements.

  • Unscrew the four screws on the top of the circuit board in a left-to-right fashion. After pull screws out of the board.

Voeg opmerking toe

  • Follow steps 1-4 to remove the front, back, and top covers of the fan to reach the fan blades.

  • Use a cloth to clean off dust clogged in between the fan blades.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Vivian Fong

Lid sinds: 26-09-12

70 Reputatie

1 Handleiding geschreven

Team

Cal Poly, Team 15-46, Forte Fall 2012 Lid van Cal Poly, Team 15-46, Forte Fall 2012

CPSU-FORTE-F12S15G46

5 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 6

Afgelopen 7 Dagen: 18

Afgelopen 30 Dagen: 101

Altijd: 5,241