Repareer je spullen Gemeenschap Winkel

Circuit Board

Inleiding

Use this guide in order to remove the circuit board of the LG VX8350.

Wat je nodig hebt

  1. Circuit Board, Battery: stap 1, afbeelding 1 van 2 Circuit Board, Battery: stap 1, afbeelding 2 van 2

    • Locate the horizontal grip located on the back cover of the phone.

    • Slide the back cover down and off of the phone.

    Bewerken

  2. Circuit Board: stap 2, afbeelding 1 van 2 Circuit Board: stap 2, afbeelding 2 van 2

    • Insert a plastic opening tool into the battery release point located above the battery.

    • Pull outwards in order to release the battery.

    Bewerken

  3. Circuit Board, Circuit Board Housing: stap 3, afbeelding 1 van 3 Circuit Board, Circuit Board Housing: stap 3, afbeelding 2 van 3 Circuit Board, Circuit Board Housing: stap 3, afbeelding 3 van 3
    Gereedschap gebruikt in deze stap:
    Tweezers
    $4.99
    Koop

    • Locate the 5 screws holding the body of the phone together.

    • The top screw will have a plastic cover, remove it using tweezers.

    • Using a Philips head screwdriver, twist counterclockwise to remove the screws.

    • Take special care with the screw located at the top of the phone. It is smaller and more likely to be damaged or improperly attached.

    Bewerken

  5. Circuit Board: stap 4, afbeelding 1 van 2 Circuit Board: stap 4, afbeelding 2 van 2

    • Lift the back cover starting at the bottom of the phone.

    Bewerken

  6. Circuit Board: stap 5, afbeelding 1 van 2 Circuit Board: stap 5, afbeelding 2 van 2

    • Remove the back cover completely from the phone.

    Bewerken

  7. Circuit Board, Circuit Board: stap 6, afbeelding 1 van 1

    • Locate the clamp at bottom right side of the Circuit Board.

    • Pull the circuit board from the phone being cautious to pull out underneath the clamp.

    Bewerken

  8. Circuit Board: stap 7, afbeelding 1 van 2 Circuit Board: stap 7, afbeelding 2 van 2

    • Locate the ribbon connecting the circuit board to the phone display.

    • Using the spudger, disconnect the ribbon connecting the phone's display and the circuit board.

    • Remove the circuit board

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

Auteur

met 4 andere bijdragers

Jonathan Flowers

Lid sinds: 10/18/13

607 Reputatie

6 handleidingen geschreven

Medailles: 8

+5 andere badges

Team

Clemson, Team 14-7, Benson Fall 2013 Lid van Clemson, Team 14-7, Benson Fall 2013

CLEM-BENSON-F13S14G7

3 Leden

16 handleidingen geschreven

0Gids Commentaar

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 2

Afgelopen 7 dagen: 10

Afgelopen 30 dagen: 26

Altijd: 568