Onderdelen

Geen onderdelen nodig.

Using a Phillips #00 screwdriver, remove the four 1.1mm long screws from the top side.
  • Using a Phillips #00 screwdriver, remove the four 1.1mm long screws from the top side.

Voeg opmerking toe

Using a Phillips #00 screwdriver, remove the four 1.1mm long screws from the bottom side.
  • Using a Phillips #00 screwdriver, remove the four 1.1mm long screws from the bottom side.

  • Remove the warranty sticker across the bottom.

Voeg opmerking toe

  • Gently lift off the back and front casing.

  • The outer shell should easily come apart.

Voeg opmerking toe

  • Make sure the device screen is face down.

Voeg opmerking toe

  • Using the plastic opening tool, wedge the tool underneath the bottom left edge of the hard drive.

  • Raise the bottom edge of the hard drive 15 degrees up from the device.

Voeg opmerking toe

  • Place fingers on the IDE connectors and gently slide the hard drive out from the IDE module.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Ryan Sutardji

Lid sinds: 29-06-12

171 Reputatie

7 handleidingen geschreven

Team

Cal Poly, Team 1-4, Regan SU 2012 Lid van Cal Poly, Team 1-4, Regan SU 2012

CPSU-REGAN-SU12S1G4

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 2

Altijd: 807