Inleiding

This guide will teach you how to replace your printer's right side transformer. Do not touch anything other than what is specified, specifically on the green board. You may accidentally short or damage the electrical configurations or give yourself an electric shock.

Onderdelen

Geen onderdelen nodig.

Lift the printer lid up as shown in the photo.
  • Lift the printer lid up as shown in the photo.

Voeg opmerking toe

Locate and remove the two 10mm side screws. There is one on each side. Locate and remove the two 10mm side screws. There is one on each side.
  • Locate and remove the two 10mm side screws. There is one on each side.

Voeg opmerking toe

Unhook the plastic panel from the printer starting from the top. You may need to wiggle the panel a bit to loosen it.
  • Unhook the plastic panel from the printer starting from the top.

    • You may need to wiggle the panel a bit to loosen it.

  • To remove the bottom part of the paneling gently lay the printer on its back.

    • The scanner lid needs to be supported when moving the printer

Voeg opmerking toe

Gently unhook the right side paneling (as looking at the printer's front face) from the printer. Use a gentle back and forth motion to wiggle the hooks out. Use a gentle back and forth motion to wiggle the hooks out.
  • Gently unhook the right side paneling (as looking at the printer's front face) from the printer.

    • Use a gentle back and forth motion to wiggle the hooks out.

Voeg opmerking toe

Locate the yellow wire connected to the metal box. Carefully pull the yellow wire from the black connector.
  • Locate the yellow wire connected to the metal box.

  • Carefully pull the yellow wire from the black connector.

    • Wires may detach completely from plug so tug very gently.

Voeg opmerking toe

Locate the spring. Unhook the spring on the side of the metal box.
  • Locate the spring.

  • Unhook the spring on the side of the metal box.

Voeg opmerking toe

Unscrew the 10mm screw attaching the metal plate to the printer.
  • Unscrew the 10mm screw attaching the metal plate to the printer.

Voeg opmerking toe

Lift the transformer out of the printer.
  • Lift the transformer out of the printer.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Helena Yanez

Lid sinds: 29-09-13

446 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 13-1, Forte Fall 2013 Lid van Cal Poly, Team 13-1, Forte Fall 2013

CPSU-FORTE-F13S13G1

5 Leden

8 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 3

Afgelopen 7 Dagen: 8

Afgelopen 30 Dagen: 25

Altijd: 1,681