Inleiding

If the back lock-release lever is loose or broken, this will allow you to attempt to replace it.

Onderdelen

Geen onderdelen nodig.

Open up the battery door.
  • Open up the battery door.

Voeg opmerking toe

Remove the batteries from the camera by sliding them out into your palm.
  • Remove the batteries from the camera by sliding them out into your palm.

Voeg opmerking toe

  • Release the side latch to open the back panel.

Voeg opmerking toe

  • Remove the two black 4.5mm screws above and below the latch.

Voeg opmerking toe

  • Using your finger, carefully pry open the side panel from the top of camera.

  • Pull panel downwards to remove.

  • Make sure to keep track of the small black piece of rubber under the latch.

Voeg opmerking toe

  • Remove the two silver 6mm Phillips #1 screws.

Voeg opmerking toe

  • Flip camera over to the bottom.

  • Remove the one 5mm Phillips #1 silver screw.

Voeg opmerking toe

  • Remove the front panel by pulling away from the side with the lever.

Voeg opmerking toe

  • Pull off the lever by pushing up from the bottom and pulling away from the bottom.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Jordan Tang

Lid sinds: 24-01-14

531 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 6-20, Maness Winter 2014 Lid van Cal Poly, Team 6-20, Maness Winter 2014

CPSU-MANESS-W14S6G20

4 Leden

11 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 3

Afgelopen 30 Dagen: 14

Altijd: 569