Inleiding

If the button on an Atari Flashback 2 console is sticking or broken, then it will need to be cleaned or replaced. This guide covers the steps necessary to disassemble the console in order to access the buttons to do so.

Onderdelen

Geen onderdelen nodig.

  1. Using the screwdriver and the PH1 bit, unscrew the five 10.0 mm screws on the bottom of the console.
    • Using the screwdriver and the PH1 bit, unscrew the five 10.0 mm screws on the bottom of the console.

    • One screw is under the main sticker in the middle of the console.

    Voeg opmerking toe

  2. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
  3. Unscrew the six 9.0 mm Phillips #1 screws on the brown circuit board that correspond to the reset and select buttons.
    • Unscrew the six 9.0 mm Phillips #1 screws on the brown circuit board that correspond to the reset and select buttons.

    • Remove gently. The circuit board is connected by wire to the console. Removing the cable from the console case may allow more slack.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Gabriel Robinson

Lid sinds: 17-09-18

85 Reputatie

1 Handleiding geschreven

Team

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 5

Afgelopen 30 Dagen: 18

Altijd: 29