Word lid van de reparatiegemeenschap - Account aanmaken

Inleiding

This guide will show you how to open the back panel. This will allow the user to gain access to the device components and is necessary for most replacements and repairs for the Apex Tablet 7.

Wat je nodig hebt

1. Stap 1 Back Panel
  Unscrew the two 2.70 mm Phillips #00 screws on the side of the tablet that has the buttons and the headphone jack (bottom side when holding upright).
  Bewerken
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
2. Stap 2
  CAUTION: When removing the back panel of the tablet, take caution around the speaker. This is located in the lower right corner when looking at the back of the tablet. There are two wires inside connecting the tablet back panel to the device itself and this connection may be severed if the back is pulled off without care.
  
  This connection is shown in red on the pictures.
  Bewerken
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
4. Stap 3
  Slide a plastic opening tool in between the edge of the back panel and the the top edge of the device.
  
  Run the plastic opening tool along the sides of the tablet while keeping it in the crack between the tablet and the back panel to create an opening.
  Bewerken
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
5. Stap 4
  Apply pressure using your hand to pop the back panel off slowly, taking extra care around the speaker connection.
  Bewerken
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
6. Stap 5
  The back panel should now be disconnected from the device. This provides access to the components of the device for repairing and replacing parts of the tablet.
  Bewerken
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024