Inleiding

The front panel may need to be replaced if it is cracked or damaged.

Onderdelen

Geen onderdelen nodig.

Power off your AlphaSmart Pro device and remove the batteries before beginning disassembly.
  • Power off your AlphaSmart Pro device and remove the batteries before beginning disassembly.

  • Remove all eight 1 cm Phillips head screws from the back panel of the AlphaSmart Pro with the Phillips #00 Screwdriver.

  • Carefully separate the front panel from the back panel.

  • Notice that the front and back panels are still connected by a ribbon cable.

Voeg opmerking toe

To remove the ribbon cable, use the spudger to lift each side of the connector from the socket.
  • To remove the ribbon cable, use the spudger to lift each side of the connector from the socket.

  • Gently pull up on the connector to completely remove the connector from the socket.

  • You are now able to separate the front panel from the back panel.

Voeg opmerking toe

  • Looking at the front panel, use the Phillips #00 screwdriver to remove the four Phillips head 0.8 cm screws from each corner of the display motherboard.

  • Lift the display screen and motherboard from the plastic front panel to separate the two pieces.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Nathan Smith

Lid sinds: 13-10-14

4 Reputatie

2 handleidingen geschreven

Team

Clemson, Team 1-1, Benson Fall 2014 Lid van Clemson, Team 1-1, Benson Fall 2014

CLEM-BENSON-F14S1G1

4 Leden

8 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 2

Altijd: 155