Inleiding

Upgrade or replace RAM.

Remove the screws on the large panel. Lift up the panel.
  • Remove the screws on the large panel.

  • Lift up the panel.

Voeg opmerking toe

The RAM slots are located in the corner opposite to the cooling fan. To remove existing RAM cards: there are clips holding the sides of each card. Simultaneously spread both right and left clip and the card will pop upward. Then it can easily be pulled out. Slide in the RAM at a 45 degree angle.
  • The RAM slots are located in the corner opposite to the cooling fan.

  • To remove existing RAM cards: there are clips holding the sides of each card. Simultaneously spread both right and left clip and the card will pop upward. Then it can easily be pulled out.

  • Slide in the RAM at a 45 degree angle.

  • Press down on the RAM until it snaps into place.

  • A good amount of pressure is needed to snap it in place.

  • Install the RAM in the left (lower) slot before installing RAM in the right (upper) slot

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

7 andere personen hebben deze handleiding voltooid.

Brad Rollinson

Lid sinds: 29-09-10

1.089 reputatie

8 handleidingen geschreven

Team

Cal Poly, Team 14-39, Forte Fall 2010 Lid van Cal Poly, Team 14-39, Forte Fall 2010

CPSU-FORTE-F10S14G39

5 Leden

9 handleidingen geschreven

Één commentaar

being a novice ram replacement i found this to be exactly what i needed to know thankyou very much.

bruce johnson - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 7

Afgelopen 7 Dagen: 14

Afgelopen 30 Dagen: 55

Altijd: 14,468