Ga door naar hoofdinhoud
Preview of the first page of this document

Log in to view the full document

7 pagina's · 4.97 mb · PDF

Inloggen

Last modified: 04/03/2020 13:57:57

Trim - A-Pillar - Upper - LH (Remove and Replace)

Correction code 15184002 FRT 0.05

NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.

NOTE: See to learn more about FRTs and how they are created. To provide feedback on FRT values, email . Make sure to wear proper PPE when performing below procedure. Flat Rate Times LaborTimeFeedback@tesla.com

Remove

  • Open the LH front door.
  • Remove the LH instrument panel end cap. See . End Cap - Instrument Panel - LH (Remove and Replace)
  • Remove the LH middle A-Pillar trim. See . Trim - A-Pillar - Middle - LH (Remove and Replace)
  • Release the clips that attach the LH upper A-pillar trim to the A-pillar.

Note

Release the top clip first and work forward and down.

  • Depress the tabs (x2) that attach the LH upper A-Pillar trim tether to the body, and then remove the tether from the body.

  • Pull upwards to remove the LH upper A-pillar trim from the vehicle.

Note

Remove any remaining LH upper A-pillar trim clips from the LH A-pillar, and if the LH upper A-pillar trim is to be later installed, remove all clips from the trim.

Install

  • Position the LH upper A-pillar trim tether on the body, and then press the tether into the body to engage the tabs (x2).

  • Insert the front lower edge of the trim into the instrument panel carrier, and then firmly fasten the clips that attach the LH upper A-pillar trim to the A-pillar.

  • Note

Fasten the bottom clip first, and then work toward the top.

  • Note

Look through the windshield from outside of the vehicle to check that the LH upper Apillar trim is flush with the A-pillar.

  • Pull the primary front side body seal over the LH upper A-pillar trim.
  • Install the LH middle A-Pillar trim. See . Trim - A-Pillar - Middle - LH (Remove and Replace)
  • Install the LH instrument panel end cap. See . End Cap - Instrument Panel - LH (Remove and Replace)