Repareer je spullen Gemeenschap Winkel

Second generation of Wi-Fi iPad, released on March 11, 2011. Model number A1395. Repair is difficult and will require heat.

250 Vragen Bekijk alle

Opties

Digitizer replaced / Touchscreen does not work

Hello -

I had an iPad 2 WiFi with a cracked digitizer/glass. I ordered a replacement digitizer/front glass from a leading iPad parts company (no junk). I removed the old digitizer/glass and installed the new one. Everything went flawless and the video connector from the new digitizer is perfectly inserted into the board connector. All of the buttons work BUT I can not get the new digitizer to work. I even installed a second one I purchased just to make sure but I can not get the digitizer to work. Any suggestions? Thanks!

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 2
Voeg een opmerking toe

2 Antwoorden

Filteren op:
Meest nuttige Nieuwste Oudste
Gekozen oplossing

Opties

I have resolved the issue...thankfully. I have repaired electronics my whole life but it seems that the two-prong video connector cable off of the digitizer connects to the motherboard UPSIDE DOWN. I know that sounds strange, but if your digitizer does not work after replacing it, reverse these cables and put them in what most would think to be upside down (which in this case, is correct).

Was dit antwoord nuttig?

Ja Nee
Score 3

2 opmerkingen:

what do you mean upside down?

how do you fix it?

i have the same problem

door

This has resolve my issue!!

door

Voeg een opmerking toe

Opties

I had same problem, make sure the white perferated line is facing up, my problem is half of the touch screen is unresponsive. Any help, something i did? Bad screen?

Was dit antwoord nuttig?

Ja Nee
Score 2
Voeg een opmerking toe

Voeg je antwoord toe

rick zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 3

Afgelopen 30 dagen: 5

Altijd: 6,431