Repareer je spullen Gemeenschap Winkel

CD-Receiver with USB Interface Released in 2015

4 Vragen Bekijk alle

Opties

miswiring check wiring then pwr on

A simple installation in a 1995 jeep wrangler.   Kenwood KMR-D562BT.  The radio runs perfectly with ignition in "Accessory" position.   It also works perfectly in the "ignition ON position.  But 2-3 minutes after I start the engine I get MISWIRING CHECK WIRING THEN POWER ON.  I have tried "reset" I have checked to no avail to see what is the difference in power in or out between ignition ON and engine running.  Nope.   I cleaned all the little wires running to the circuit board. Nope  Mysterious.

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0
Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste
Gekozen oplossing

Opties

It could be an interference problem since it only happens with the engine running. Make sure you have all the speaker wires and there terminals insulated.

Was dit antwoord nuttig?

Ja Nee
Score 1

2 opmerkingen:

Thanks Chris. That's what the manual says as well. The wires going to the plug at the radio are firmly engaged in the plug and their insulation is intact down to the plug face. Does this mean i need to start pulling out speaker wiring? What if I disconnected all but one speaker at a time and see if i can isolate which one is the source of the problem? Ian

door

@ianmw Yes. That is what I would do.

door

Voeg een opmerking toe

Voeg je antwoord toe

IAN zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 4

Afgelopen 7 dagen: 30

Afgelopen 30 dagen: 144

Altijd: 5,407