Ga door naar hoofdinhoud

Released in 1991, this page relates to the SNS-005 model Super Nintendo controller, released for U.S. markets.

1 Vragen Bekijk alle

Wire Shielding is Pulled out of controller housing

I have a well loved SNES and two original controllers with it, both of which have the shielding of the wires pulled out of the controller shell which I assume just pulled out over time and use. My question is, how is the best way to go about covering the wires again? the best solution I could think of is to buy heat shrink tubing and just ad length to the shielding. But that there also leads to a problem because of the pin connector to the pcb being to large. any ideas or am I over thinking this?

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
Voeg een opmerking toe

1 Antwoord

Hello, perhaps you can cut two shrink tubes and hold them with zip ties without heating them.

Was dit antwoord nuttig?

Score 0
Voeg een opmerking toe

Voeg je antwoord toe

Jon Heliseva zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 1

Afgelopen 30 dagen: 2

Altijd: 31