Rep: 13
1
1
Washer does not seem to go into "high" spin cycle and leaves heavy item wet at end of cycle. Tried to extend spin cycle, and tried to re-run entire wash cycle with no improved results.
Is dit een goede vraag?
Rep: 685,4k
3,4k
1,1k
2,6k
This can be caused by any one of these:
When the clothes are wet at the end of a cycle, check these:
Motor coupler
Spin cycle
Siphoning
Water-inlet valve
Let us know if it starts happening again for more detail.
Was dit antwoord nuttig?
The washer was working fine then a pop and rubber burning smell. Now it has the same symptom as above
and I only have a towel in the washer and it does not get to a high speed spin. It toggles back and forth to a relative slow spin for a little stops and then changes directions and keeps doing that and then finishes as if all went ok
Thanks Stan B
Was dit antwoord nuttig?
Afgelopen 24 uren: 0
Afgelopen 7 dagen: 0
Afgelopen 30 dagen: 3
Altijd: 2,701
2 opmerkingen
The first thing I would try is to use a smaller, lighter load. The load may be so heavy it can't get up to speed.
door rj713
I ran the small bathroom rug back through wash cycle with other items & it finally spun correctly. Thanks!
door Ybsul