Rep: 50
3
1
My washer begins it’s cycle, then it drains partially, then continues with its cycle. This caused an accumulation of water in the tub to the point where the unit is half full of water.
I am afraid to put in a new pump because the pump is working, just will not run until the tub is empty.
This unit is a LG model # - WM3180CW
Is dit een goede vraag?
Rep: 1
2
Does your machine start as soon as the pump stops? If so then you pump is fine and you may have a water level sensor out of place or defective, worse case is the control board.
Was dit antwoord nuttig?
Yes. When I turn on machine and select a cycle, the unit starts by draining for about 6-7 seconds. Then it begins the cycle. Could it possibly be a pressure switch?
Afgelopen 24 uren: 0
Afgelopen 7 dagen: 1
Afgelopen 30 dagen: 1
Altijd: 37
