Repareer je spullen Gemeenschap Winkel

Repair information and guides for the iPhone 6 Plus that was released on September 19, 2014. Model: A1522, A1524

1525 Vragen Bekijk alle

Opties

iPhone 6 Plus Error 4013 after Screen, Logic, and Lightning replaced

I recently gained possession of an iPhone 6 Plus that I replaced the screen on for a friend. The phone then proceeded to boot loop until it ran out of power. Thinking that the device was fubar, he gave it to me. So I decided to try basically everything. Got to the point that I decided to replace the logic board after having heard that error 4013 can be NAND related. Did that. Still get the exact same error whenever I try to restore it with iTunes.

64GB AT&T Locked iPhone 6 Plus

Parts replaced:

  • Screen
  • Lightning and audio assembly
  • Logic Board
  • 5GHz wireless antenna

Any insight?

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0
Voeg een opmerking toe

2 Antwoorden

Filteren op:
Meest nuttige Nieuwste Oudste
Het nuttigste antwoord

Opties

disconnect everything except chargeport and see if it will flash without errors, then if it goes through ok start connecting each component one at a time until you find the culprit.

Was dit antwoord nuttig?

Ja Nee
Score 1

3 opmerkingen:

well... seems like the screen was the problem, but that raises a new question... how come a screen that was purchased from iFixit didn't let the phone boot or restore...

door

So, that "fixed" it, but now it just boot loops forever again... And I can't test the original screen anymore because it was practically unusable when I replaced it.

door

Bad front camera or home button flex from a screen that has preassembled components can cause this.

door

Voeg een opmerking toe

Opties

That is Nand issues,Most of the cases you have to reprogram Nand with removing from logic board and reprogram with programmer.

Was dit antwoord nuttig?

Ja Nee
Score 0

1 Opmerking:

The logic board has already been replaced with a known good board. So the issue is no longer NAND related. Also, I was able to get it restored by taking the replaced screen off. So the issue is now with the screen and that it causes a boot loop whenever it’s connected.

door

Voeg een opmerking toe

Voeg je antwoord toe

John Peters zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 73