Ga door naar hoofdinhoud

Model A1312 / Mid 2010 / 3.2 GHz Core i3 or 2.8 & 3.6 GHz Core i5 or 2.93 GHz Core i7, ID iMac11,3

383 Vragen Bekijk alle

No power, diagnostic light goes out when power button is pressed

Hello. It's a 2390.

No power, no noise, absolutely nothing.

When I plug the power cord in, one light lights up, but then goes out as soon as I press the power button. The light doesn't come back on until I unplug it and plug it back in.

But still no noise, absolutely nothing.

Most common answers here are power supply board or logic board, but in those posts, the folks hear some sort of noise, clicking, fans or something. Mine does nothing.

Any thoughts?

Thank you,

Christina

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Score 1
Voeg een opmerking toe

1 Antwoord

Het nuttigste antwoord

Did you check the DC side of the power supply with a volt meter? Did you try a different AC power cord just incase its bad?

I would still replace the power supply as you clearly have a power issue.

Update (02/16/2018)

Block Image

Block Image

Was dit antwoord nuttig?

Score 1

2 opmerkingen:

Hello. I did check with another power cord, sorry I didn't add that info.

I will check the wire. I have to dig around for my volt meter. As soon as I find it I will update. I did also unplug the power switch cable on the logic board, and plug it back in.

Am I wrong in thinking is odd that the power switch is cabled to the logic board? Wouldn't it make sense that the power switch cable would go directly to the power supply? Is there a cable I can check going to the power supply? That is, when I find the volt meter.

Thank you!

Christina

door

The power switch goes to the logic board not the power supply in this series.

door

Voeg een opmerking toe

Voeg je antwoord toe

Christina Leone zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 2

Altijd: 178