Rep: 31
2
Hello...
I had a problem that I was facing gohst touchs with my Iphone 6 plus, and sometime there was an area where the touche became unresponsive.
I tried to reconnect the Flex cables, the ghost touches disappeared, however , the area with the unresponsive touch became more wider, and now it's permanent,
could this happen because of a damaged touch Digitizer ?
Is dit een goede vraag?
Rep: 159,7k
11
191
368
Touch IC isn't the issue here, if it was at fault the whole screen would stop responding completely intermittently / randomly until lock, unlock phone or turning the phone off and on.
This is probably just a faulty screen or physically damaged FPC touch screen connector on the logic board.
Was dit antwoord nuttig?
Rep: 307
4
1
touch IC problems with the six plus are common. when you reconnected the flex cables (pushing) on the logic board it made a temp connection. The touch IC can be repaired by a microsoldering technician or the phone will be replaced at apple for 149.99. https://ifixit.org/blog/8309/iphone-6-pl.... If the touch problem started prior to your flex cable adjustment rarely does a new screen correct the problem.
Was dit antwoord nuttig?
But most of the time, Touch IC problems affects the screen as a hole, not a specific area.
Afgelopen 24 uren: 0
Afgelopen 7 dagen: 0
Afgelopen 30 dagen: 0
Altijd: 62
1 Opmerking
Update:
When I tried and to disconnect and reconnect the flex cables, the unresponsive area got narrower and also it's now got closer to the middle..
door Omer