Rep: 13
1
1
After machine has filled up with water and is starting the wash cycle f 05 error code comes up. Went through diagnostic test in the manual and goes through c:00-c:08 with no problem. Try to wash a load, still comes up with f 05 code. The manual says it is a water temperature sensor error, but there is no heating element present.?
Is dit een goede vraag?
Rep: 10,2k
45
20
47
According to the manual, that washer takes in hot and cold water and adjusts the ratio to achieve the desired temperature, so it doesn't need a heating element. Sounds like you need to replace the temperature sensor.
Was dit antwoord nuttig?
+ Here's a link to the temperature sensor parts: http://www.repairclinic.com/Kenmore-Wash...
Rep: 25
1
It could be that the lid lock sensor is wet, or dirty. I opened it up while it was going to add a garment. Then it wouldn’t stop F05, and washer wouldn't even do anything except shut off after I turned it on! Then, I noticed it was making a faint tapping sound by the lid lock. I opened it up and listened closer, then realized it was coming from that area. I cleaned off the sensor with a dry towel, on both the lid and the sensor on the inside of the washer where the lid lock clicks. PROBLEM SOLVED!!!! Cost: ZERO!!!!
Was dit antwoord nuttig?
How did you go about fixing it and how to open it up to get to it? Location of sensor please
Afgelopen 24 uren: 2
Afgelopen 7 dagen: 27
Afgelopen 30 dagen: 62
Altijd: 13,353
