Rep: 21
2
3
Hey, today I replaced the screen of an iPad Air 2. Now the screen stays black even if I try it with the old LCD screen and digitizer. The iPad was not powered on when I replaced the screen. So I think it's not the backlight.
iTunes recognizes the iPad... Any ideas?
Is dit een goede vraag?
Rep: 159,7k
11
191
368
If I'm correct you can lift up the battery connector after unscrewing the battery without taking the logic board out.
Anyway try holding the power and reset button for 15 seconds and try turning it on again.
Was dit antwoord nuttig?
Afgelopen 24 uren: 0
Afgelopen 7 dagen: 0
Afgelopen 30 dagen: 0
Altijd: 673
2 opmerkingen
Did you unplug the battery before unplugging and plugging in the lcd and Digitizer cable?
door Ben
No. Could this help maybe? I would have to remove the logic board. Not sure if this is an good idea ^^
door elreparero