Repareer je spullen Gemeenschap Winkel

Model A1055

107 Vragen Bekijk alle

Opties

Hard drive not recognized after installation.

Hello, my original drive was making terrible noises and I couldn't even reformat the drive. So I bought a new drive. I did the complete process to install the drive and the computer did not come up at all. I re-installed the original drive and the computer started up fine the first time. The next time it would not start. I reset the PRAM and from then on the computer does not recognize either one of the drives, it does not show the hard drive during OSX installation. Neither the original drive, nor the new drive.

Thanks for your advice.

Peace

Erich

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score -1
Voeg een opmerking toe

2 Antwoorden

Filteren op:
Meest nuttige Nieuwste Oudste
Het nuttigste antwoord

Opties

Format the new hard drive first.

Start up from the system installation disk, go to the second screen pull down menu, Utilities, Disk Utility select the drive on the left and format it and give it one partition. Now install the system.

Was dit antwoord nuttig?

Ja Nee
Score 1

1 Opmerking:

Good procedure +

door

Voeg een opmerking toe

Opties

Check the connector

on the logic board - these were known to tear lose if handled to rough.

If this answer was helpful please remember to mark it accepted.

Good Luck,

N

Was dit antwoord nuttig?

Ja Nee
Score 0
Voeg een opmerking toe

Voeg je antwoord toe

Erich Hentschel zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 3

Afgelopen 30 dagen: 5

Altijd: 1,083