Ga door naar hoofdinhoud

Apple's 2012 first-generation 7.9-inch iPad mini, with 16, 32, or 64 GB of storage and an A5 processor.

629 Vragen Bekijk alle
Vraag afgerond

iPad Mini LCD and digitizer responding oddly after replacement

Both the digitizer and LCD were cracked, so I removed both, removing the power cable first. The install went well. I powered it up, the Apple symbol displayed, and once boot was complete, the screen went blank. I heard it start to chime, so it was still powered up, but it wasn't displaying anything. I held the Power/Home buttons to hard reset, and the screen lit up. The digitizer was responding, then after sitting for a minute, the screen went to sleep, then it wouldn't respond again without starting the hard reset again. I have not tried a factory restore, but I wanted to check the forums before erasing everything.

Was this a problem with the install, or could this be an OS issue with the new LCD screen installed? Any help or additional questions to narrow down the problem would be greatly appreciated.

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
Voeg een opmerking toe

1 Antwoord

Gekozen oplossing

Most likely it is a problem with the new part. Try checking if the connectors are not loose, albo you may try to clean the connectors gently with a toothbrush and highly concentrated alcohol like isopropanol. Remember to remove the battery before taking any actions!

Was dit antwoord nuttig?

Score 0
Voeg een opmerking toe
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 51