Ga door naar hoofdinhoud

2.4 GHz Intel Core i3 with 4 GB RAM and 1 TB hard drive, shipped with Windows 8.1 as standard

4 Vragen Bekijk alle

Toshiba Satellite C50-A-1CK wont boot fan spins no display

Remove and test:

Battery

RAM( replace with another RAM)

HDD

CMOS battery

nothing works.

also as a last resort tried and reflow the motherboard chipset but still the same results

any ideas?

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
Een opmerking toevoegen

2 Antwoorden

I had this did oven reflow 220 degrees C for 8 minutes

worked

but when i went to put windows on (to sell it)

I left it overnight finishing the install the next morning it was doing it again

motherboard seems to overheat

make sure you get it over 195 C when you reflow as that is the solder melt temp

take it out after 7 minutes

(be careful its delicate when solder is soft)

let it cool

my board was twisted after but fitted and worked ok

Was dit antwoord nuttig?

Score 0
Een opmerking toevoegen

Had the same problem here ( just putting one back together now).

Likely a PCH issue, so basically a case of dumping the board and cutting your losses. This model is having a lot of this issue.

Warming the PCH up at 150~180 probably might give you another couple of days but it'll fail again soon enough.

It's NOT likely a ball problem, rather the issue is in the internal gold connects of the chip itself.

Was dit antwoord nuttig?

Score 0
Een opmerking toevoegen

Voeg je antwoord toe

nearxos zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 9

Altijd: 1,240