Rep: 25
3
1
I have a MacBook Air that sometimes doesn't startup at all.
So I ran the TechTool Pro 8 diagnostic on it and it has a sensor failure: DC In failed at 16.96v.
Does anyone know if there is a way I can fix this other than a new motherboard?
Is dit een goede vraag?
Rep: 685,3k
3,4k
1,1k
2,6k
The Mag-Safe is built into the I/O board. There does not seem to be a repair guide for this machine but there is one for the A1466 2012. Take a look: MacBook Air 13" Mid 2012 I/O Board Replacement
Was dit antwoord nuttig?
Rep: 67
3
1
I just replaced the part for a brand new one from IFIXIT and it didn't fix the problem.
I'm still get the DC-in Rail 0 Failed at 16.67 V.
Anybody else managed to fix it?
thx
Was dit antwoord nuttig?
You'll need to trace the voltage from the I/O board back to the main board as you have a disconnect along the pathway.
I had the same issue and I fixed it by using the right charger. No more errors now!
Was dit antwoord nuttig?
Right…charger??
Are you saying that you can use a Thunderbolt 1 port to charge a MacBook Air??
Use a genuine Apple 45W charger. Fake chargers do not have a stable voltage and can cause this issue.
Oh, the *correct* charger! I thought he was charging through the right side—i.e. the Thunderbolt port.
He was using the wrong power supply. The Air uses a 45 watt power supply at 14.5 volts. All the other laptop products use a 16.5 volt supply. So if you hook up a MacBook Pro power supply you're going to see 16.5V to 17V on the DC-in rail (depending on the accuracy of the sensor).
Afgelopen 24 uren: 0
Afgelopen 7 dagen: 0
Afgelopen 30 dagen: 8
Altijd: 3,264
1 Opmerking
You may be using the wrong power supply. The Air uses a 45 watt power supply at 14.5 volts. All the other laptop products use a 16.5 volt supply. So if you hook up a MacBook Pro power supply you're going to see 16.5V to 17V on the DC-in rail (depending on the accuracy of the sensor).
door rockpiano54