Repareer je spullen Gemeenschap Winkel

Model No. A1367 / 8, 16, 32, or 64 GB capacity

915 Vragen Bekijk alle
Vraag afgerond

Opties

Replaced screen, it worked when I tested it, white screen after.

i just replaced the screen lcd and digitizer on my ipod 4 gen 32gb. i opened it up replaced the screen got everything hooked up and plugged it in to test it, the screen worked perfect so i then put the adhesive around the screen plugged the screen in again to make sure that i hadn't wiggled anything loose and again it worked perfectly. but then once i placed the screen and got it in place and closed up the screen now just turns white whenever anything is touched.....any insight would be greatly appreciated....

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0

1 Opmerking:

try hard reset by holding the power button and homebutton at the same time

door

Voeg een opmerking toe

4 Antwoorden

Filteren op:
Meest nuttige Nieuwste Oudste

Opties

just had same issue.

I am going to try the hard reset. I hope that fixes it.

Will update in a bit.

Was dit antwoord nuttig?

Ja Nee
Score 0

1 Opmerking:

I hard resetted the ipod and it worked out after that.

I think i might have thrown out some screens because they had the white screen. :(

Thanks socoldanny82

One more thing: Usually when I install some lcds on the corners it will have some time of bleeding when I touch the non-lcd corners. It will go back to normal after only a good 2 seconds. I still do not like to leave them for customers like this. I used a new 1mm adhesive and I think it had to with that.

door

Voeg een opmerking toe

Opties

if reset does not fix it, just replace the screen again - sometimes the flex ribbon on the LCD gets worn very easily on these

Was dit antwoord nuttig?

Ja Nee
Score 0
Voeg een opmerking toe

Opties

Rlarajr I have the same problem after replacing an iPod 4 screen assembly. The bottom of the screen is fine but when you push on the top of the digitiser the LCD bleeds : ( anyone have a fix for this problem?? Thanks

Was dit antwoord nuttig?

Ja Nee
Score 0
Voeg een opmerking toe

Opties

I have exactly the same problem. Anyone with a solution? the screen is working fine. But only when reassembling it gives the bleed problem. I try'd with and without adhesive..

Was dit antwoord nuttig?

Ja Nee
Score 0
Voeg een opmerking toe
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 3

Afgelopen 30 dagen: 4

Altijd: 503