Ga door naar hoofdinhoud
Help

Deze versie is geschreven door: oldturkey03

Titel:

Starts, surges and dies

Tekst:

Ok. I have a 5hp Briggs & Stratton on my MTD rototiller.  I've changed the carb gasket, see picture. I've cleaned out the passages. I've used sea foam in the fuel, it's got fairly new gas. I cleaned and checked the gap in the spark plug and it's good. I can still see through the air filter.

But I can start it and it'll run for a few minutes then die. After the sea foam trick if I babied it I was able to do a little bit of rototilling, but then it died and wouldn't restart no matter where I positioned the choke lever.

What else could it be?

[image|2120679]

Toestel:

-Mtd rototiller
+4-Stroke Small Gas Engine

Status:

open

Origineel bericht door: Aaron

Titel:

Starts, surges and dies

Tekst:

Ok. I have a 5hp Briggs & Stratton on my MTD rototiller.  I've changed the carb gasket, see picture. I've cleaned out the passages. I've used sea foam in the fuel, it's got fairly new gas. I cleaned and checked the gap in the spark plug and it's good. I can still see through the air filter.

But I can start it and it'll run for a few minutes then die. After the sea foam trick if I babied it I was able to do a little bit of rototilling, but then it died and wouldn't restart no matter where I positioned the choke lever.

What else could it be?

[image|2120679]

Toestel:

Mtd rototiller

Status:

open