Vitali

eMac Display looking pretty bad but machine working pretty good ! I don't have any experience with CRT devices. Any...

iPhone not powered up, can not restored. Error 2001. Booting up only from wall charger, charging. After country...

Hi, my internal microphone not working but recognized by system . If I knock around a microphone input level shows a...

Hi, I decide to install a primary SSD instead of my SuperDrive in my old 24 inch , 2,4 C2D . But it's a ATA interface for...

iMac G4 20 inch model has a blank screen. But working fine when connect to the external monitor over miniVGA. Screen...

Powermac G5 , 2.3 DP not starting anymore. Power button LED blinking and something ticking pretty loud inside . Any ideas?...

HDD not recognized in Disc Utility. Did a swap HDD from another iMac, cant recognize as well. I did PMU reset, re-checked...

Is it possibele to replace defective LCD panel on the 17 inch A1107 from A1085, or A1052, A1013 models ? Thank you

Macbook White A1181 2.16 C2D overhaeted after SSD instalation. Temperature rise to 67-75 Celsius. Freshly installed...

Hi, my G4 A1107 has a cracked screen. Complete display from A1001 can be fit in my A1107? Thansk

iPhone 3GS endless reboot after battery replacement fix With a lot of iPhone 3GS units now requiring replacement batteries, but with no original batteries available, sometimes after a replacement when the power percentage drops to 30~50% the iPhone will turn off, but when you try to turn it back on again it goes in to an endless cycle of showing the Low-Battery screen and then attempting to start with the Apple logo, then restarting all over again in a minute or two. The exact cause of the problem isn't known, though a mismatch between the presumed or old battery charge curve and the new battery is likely. Mostly the iOS installed thinks that the battery still has 30~50% of power left when in fact it empty, a lot of this is because lithium cells have an exceptionally flat discharge curve and thus estimating the energy left is not always practical without keeping track of the mAh consumed. Put the iPhone 3GS into DFU/Recovery mode Hold down the power button for 4 seconds Hold down the home button for 10...

My iMac has the same issue with LCD. I found LCD itself was defective (idtech m201z2 ).

Hi, I have the same issue with my Macbook A1226. Did you fix it ? Thanks

Hi, did you check a power from Power Supply to LCD?

Hi, I had PSU problem with my Imac. I bought a NEW Apple PSU from ebay for 79$. in my opinion, don't spent a lot of time to find a schematics to math connectors. Hi risk to fried you logic board.