MacBook Pro won't boot with or without batteryHi everyone, I’ve read quite a few articles on here but haven’t found one with the exact issue i am seeing - apologies if...
Antwoord op "Remote central-locking system not working on Nissan Almera?"If the central locking is working when using the switch inside the car, but isn’t working from the key … then have you checked the key? changed the battery? or sometimes you need to ‘re-sync’ the key with the car
Antwoord op "Won’t go over 2rpm"It definitely sounds like it is in ‘limp home’ mode … this keeps the revs below 2000 - 2500 RPM. It could be a number of things … but as you have already replaced a few components it makes sense to reset the ECU and then see if the error persists. So … with the drivers door open disconnect the positive battery terminal then press the brake pedal a few times to make sure there’s no electrical power left in the system. Keep the battery unplugged for at least 10 minutes before connecting it back up and starting the car. If the problem still happens then you will need to get the error codes checked with an OBD scanner
Antwoord op "Slip TCS lights on won't go past 10 mph"I’ve had this on a 2003 Nissan 350GT. The slip and TCS lights seem to be the light combo of choice for Nissan for any number of faults. It sounds like your ECU has gone into ‘limp home mode’ and you will need to get the error codes checked to pinpoint the issue. Either connect an OBD scanning tool to the OBD port under the steering wheel (or take it to a garage) or if you don’t have a scanner you can try the Nissan ‘pedal dance’ which can be tricky to get the timing right but here is a link to it : https://www.nissanhelp.com/diy/common/ni...? the error codes will then be flashed up by the Engine Check Light on the dash … once they’re flashing i find it useful to video the flashing sequence on my phone and then translate them afterwards.