Change of plans. I just swapped out the boosted v1's original electronics with something else. I took out the 39.6 volt battery with the BMS and took out the esc (circuit board) Currently I am using a 24/36 volt esc I got from eBay and I am using a Ryobi 40 volt 6.0 ah lithium battery. I ran it Thursday night (8/13). it ran pretty good. I am sharing the motor wires from each motor for the single connection. In other words 2 motor wires from each motor are into each if the 3 connections. And I have to run it without the hall sensors. Because for some strange reason, when the hall sensors are plugged in, I can not turn on the power….. however with the hall sensors unplugged, I can turn on the power. Other than that, it runs pretty decent. Only thing is jerky take off. I think its because there is no hall effect.