BIG NOTE: The entire bottom surface of the usb port is soldered down. You must first desolder the 5 contacts then heat the entire port until it comes loose.

You will need to plug in both cameras first and install them together with the Mboard as the connectors are on the underside.

You can also lift the rear facing camera out. It’s held in only by some double sided tape. This will be necessary to plug it back in anyways.

You only need to remove the speaker on the right of this photo, you can leave the other, longer one, in place.

You only need to free the antenna from the case. Leave it hanging from the Mboard.

You do not need to disconnect the antenna power cable. You only need to disconnect the other 2 black power cables. Just pull the antenna out together with the Mboard.

You do not need to remove the battery.

Thanks for the tips. I recommend using a de-soldering tool instead of braid though. It’s basically a spring loaded syringe that works backwards, sucking up the molten solder.

Thanks for the tip, I’m about to change the port in mine.

This guide doesn’t mention what type of adhesives will work for reassembly?