Ga door naar hoofdinhoud
Help
Bewerken van stap 5 —

Stap type:

Sleep om te herschikken

After a good twenty #00 Phillips screws were removed from the perimeter of the device, we managed to separate the rear cover.

A ribbon cable for the rear control buttons and a hefty 40 pin cable responsible for transmitting information to the rear display still attached the rear cover to the rest of the camera.

Fun fact: to eliminate the complexities of a slip ring on the rotating rear display, its motion is limited to 180 degrees.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.