Ga door naar hoofdinhoud

Wat je nodig hebt

Deze demontage is geen reparatiehandleiding. Om je ZEN V Creative Media Player te repareren, gebruik onze reparatiehandleidingen.

  1. ZEN V Creative Media Player Teardown, ZEN V Creative Media Player Teardown: stap 1, afbeelding 1 van 3 ZEN V Creative Media Player Teardown, ZEN V Creative Media Player Teardown: stap 1, afbeelding 2 van 3 ZEN V Creative Media Player Teardown, ZEN V Creative Media Player Teardown: stap 1, afbeelding 3 van 3
    • Here we have Creative's ZEN V Media Player.

    • The Navigator Stick

    • The Play/Pause Button

    • The Back Button

    • The LCD

    • USB 2.0 Charging Port

    • Headphone Jack

    • Line In Jack

  2. ZEN V Creative Media Player Teardown: stap 2, afbeelding 1 van 3 ZEN V Creative Media Player Teardown: stap 2, afbeelding 2 van 3 ZEN V Creative Media Player Teardown: stap 2, afbeelding 3 van 3
    • Start by taking a pointy metal spudger and insert it on the bottom edge of the player

    • Slide it along, prying up until a gap forms

    • Proceed to insert and slide the tool along the left and right side of the device, until the plastic piece with the buttons comes free.

    • Half of the covering plastic should be off now

    • Gap between plastics

  3. ZEN V Creative Media Player Teardown: stap 3, afbeelding 1 van 3 ZEN V Creative Media Player Teardown: stap 3, afbeelding 2 van 3 ZEN V Creative Media Player Teardown: stap 3, afbeelding 3 van 3
    • While doing the following steps note that this piece is glued on to the LCD. Do not apply too much force or shove your tool too far in

    • Glue

    • Bring your tool to the top edge of the player and insert it

    • Insert it on the top edge and slide while prying up

    • The gap

    • Insert it on the two sides and pry until plastic comes loose

  4. ZEN V Creative Media Player Teardown: stap 4, afbeelding 1 van 2 ZEN V Creative Media Player Teardown: stap 4, afbeelding 2 van 2
    • Be very gentle with the LCD in the next 2 steps! It is glued to the logic board with black stick pads. Do not break the cable/clip!

    • Adhesive Pads

    • Cable Clip

    • Insert flat end of plastic spudger on the bottom of the LCD. Pry gently upwards.

    • Bottom of LCD

    • Insert on the sides and continue to pry.

    • Finally insert on the top and pry.

    • Top of LCD

  5. ZEN V Creative Media Player Teardown: stap 5, afbeelding 1 van 3 ZEN V Creative Media Player Teardown: stap 5, afbeelding 2 van 3 ZEN V Creative Media Player Teardown: stap 5, afbeelding 3 van 3
    • Pull back LCD to bottom of player to expose cable/clip

    • Remove orange ESD safe tape with spudger/fingernail

    • Orange ESD safe tape

    • Flip up the clip with flat end of spudger/fingernail

    • Clip is flipped up

    • Pull the LCD away from the player

  6. ZEN V Creative Media Player Teardown: stap 6, afbeelding 1 van 3 ZEN V Creative Media Player Teardown: stap 6, afbeelding 2 van 3 ZEN V Creative Media Player Teardown: stap 6, afbeelding 3 van 3
    • Put down your spudger and pick up a Phillips #000 Screwdriver

    • Remove the two screws on the logic board

    • Screws

    • Remove Volume control button by pulling it up off the board

    • Volume control button

    • Pull up board from bottom of player

    • Gently wiggle the logic board out of the casing. Be careful because it is connected to a battery underneath it

    • Battery

  7. ZEN V Creative Media Player Teardown: stap 7, afbeelding 1 van 3 ZEN V Creative Media Player Teardown: stap 7, afbeelding 2 van 3 ZEN V Creative Media Player Teardown: stap 7, afbeelding 3 van 3
    • Insert spudger under the top of the battery and pry

    • Top half of battery

    • There is an adhesive pad under the battery

    • Battery should now be free

    • Remove battery from case and set aside connected to the logic board

  8. ZEN V Creative Media Player Teardown: stap 8, afbeelding 1 van 1
    • Battery may now be removed from logic board with a soldering iron

    • Heat up the contacts and pull away wires

    • Contacts

  9. ZEN V Creative Media Player Teardown: stap 9, afbeelding 1 van 2 ZEN V Creative Media Player Teardown: stap 9, afbeelding 2 van 2
    • These all are various components that can be removed with a soldering iron

    • USB 2.0 Port has 4 pads and 5 pins attaching it to the logic board

    • Various Switches- 4 pads each. From the (Bottom left), Volume up, Volume Down, Mute?, (Top Left), Power on/Hold, Reset

    • Line In Jack 4 pads

    • Headphone Jack 4 pads

    • Play/Pause Button 2 pads and Back Button 2 pads

    • LCD connector and Navigtor button

  10. ZEN V Creative Media Player Teardown: stap 10, afbeelding 1 van 1
    • All the innards of the ZEN V Media Player

    • Button Plastic- Removed in Step 2

    • LCD Plastic- Removed in Step 3

    • Orange ESD Safe tape and LCD Screen- Removed in Step 5

    • Screws and Volume Button- Removed in Step 6

    • Back Plastic Case and Logic Board- Removed in Step 7

    • Battery Removed in Step 8

Liam Speirs

Lid sinds: 11/08/09

363 Reputatie

2 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 4

Afgelopen 30 dagen: 11

Altijd: 13,549