Ga door naar hoofdinhoud

Gereedschappen die in deze demontage worden gebruikt

Inleiding

This is a basic teardown of the venerable TI-82 calculator.

Deze demontage is geen reparatiehandleiding. Om je Texas Instruments TI-82 te repareren, gebruik onze reparatiehandleidingen.

  1. The calculator comes with a matching protective shield which slides down over the front; when the calculator is in use, you can slide it over the back.  This is a nice touch, as it makes the cover much more difficult to lose.
    • The calculator comes with a matching protective shield which slides down over the front; when the calculator is in use, you can slide it over the back. This is a nice touch, as it makes the cover much more difficult to lose.

  2. Flip the device over to access the battery cover. Using a spudger, pry the release tab down and then pull the battery door up and off the calculator. Remove:
    • Flip the device over to access the battery cover.

    • Using a spudger, pry the release tab down and then pull the battery door up and off the calculator.

    • Remove:

    • 2 7.2mm Phillips #0 screws

    • 1 15.3mm Phillips #0 screw, and a battery retaining clip.

    • The CR1616 coin cell battery preserves settings and programs in memory while the main batteries are being changed.

  3. MacBook-reparatiesets voor batterijen

    Vanaf $69.99

    Buy Now

    MacBook-reparatiesets voor batterijen

    Vanaf $69.99

    Buy Now
  4. Insert a spudger into the seam between the two halves of the case, and pry it apart.
    • Insert a spudger into the seam between the two halves of the case, and pry it apart.

    • Watch out for corrosion in older calculators around the battery terminals -- this is why you should never leave batteries in electronics for extended periods of time.

  5. Opening the two halves of the calculator reveals a foil shield over the rest of the electronics.
    • Opening the two halves of the calculator reveals a foil shield over the rest of the electronics.

    • Remove four Phillips screws to access the electronics underneath, then pull the shield away.

  6. ... And, here's the guts of the thing.
    • ... And, here's the guts of the thing.

    • SRM20255LLM10 / F4ZM1938 (32Kbyte SRAM)

    • LH531GP4 (Mask ROM)

    • T 84C00AM-8 (Z80 CPU)

    • Toshiba / TC14L010AF / 1273 9506EAI (ASIC)

  7. Remove the remaining Phillips screws. The screen and main board will lift out, leaving the membrane keypad in the front case.
    • Remove the remaining Phillips screws.

    • The screen and main board will lift out, leaving the membrane keypad in the front case.

bushing

Lid sinds: 23-04-10

9.514 Reputatie

13 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 2

Afgelopen 7 Dagen: 7

Afgelopen 30 Dagen: 31

Altijd: 15,686