Gereedschappen die in deze demontage worden gebruikt

Inleiding

This is a Sony MZ-R700 minidisc, Sony's attempt to provide an alternative to portable CD players, right before the mp3 revolution. Minidiscs were particularly popular in Europe and Asia but the devices didn't catch on as much in North America. This model supports MDLP and was capable of recording up to 4 full-length audio CDs onto one small minidisc (via Sony's proprietary ATRAC format).

Deze demontage is geen reparatiehandleiding. Om je Sony MZ-R700 Minidisc te repareren, gebruik onze reparatiehandleidingen.

  1. Start by removing the 8 very small screws on both sides of the unit. The front door will still be connected via the latch.
    • Start by removing the 8 very small screws on both sides of the unit. The front door will still be connected via the latch.

    Voeg opmerking toe

  2. Next, remove 7 screws on the inside front panel. This will disconnect the frontal logic board with LCD display and remove the front panel.
    • Next, remove 7 screws on the inside front panel. This will disconnect the frontal logic board with LCD display and remove the front panel.

    Voeg opmerking toe

    • The front panel may now be removed. Next, remove one screw on the inside front panel.

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • Carefully remove the unit from the outside casing. Use a spudger or a small screwdriver to wedge it out all along the sides. The plastic casing is quite malleable and has some give to it, so don't be overly gentle.

    Voeg opmerking toe

    • Remove 2 screws under the battery case. There are 6 more screws on the logic board that need to be removed, 3 on the right-hand side and 2 on the left with the final one hidden under the battery case.

    Voeg opmerking toe

    • Next, remove the front panel from the main part of the unit. The ribbon cable connects the two. To remove, gently pull out the dark brown connector from both sides of the beige holder. This will release the ribbon cable which can then be pulled out and separated. There are three in total, two on the outside, one under the battery case and one on the lower part of the unit. The third one is on the inside of the unit.

    Voeg opmerking toe

    • Remove the remaining 10 visible screws which connect the laser eye and related mechanism. Start from the bottom up as they will release various latches and connectors from the unit.

    Voeg opmerking toe

    • Gently pry the door away from the metal enclosure. Next, remove the bar on the side of the enclosure. Pry a flathead screwdriver between them and gently remove it. Finally, remove the black gear (above the green one, removed here) which will reveal one more, tiny screw that needs to be removed. At this point you may remove any remaining latches connected to the unit. Simply pry with a small flathead screwdriver and remove them.

    Voeg opmerking toe

    • Congratulations, you have successfully completed the Sony MZ-R700 Minidisc teardown!

    Voeg opmerking toe

refo

Lid sinds: 23-10-09

41 Reputatie

1 Handleiding geschreven

Why would you do that?

Have you put it back together?

Does it work?

Richard Harris - Antwoord

Thank you! Used this guide to open my R700 :)

Bert Bré (The Milkman) - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 4

Afgelopen 30 Dagen: 30

Altijd: 17,428