Inleiding
Partial / tactical teardown, for cleaning and quick repair.
Wat je nodig hebt
-
-
Face lens down, (front on table)
-
Remove 3 screws on the lens mount
-
Remove lens mount
-
Pull / push trpod mount towards back of the lens, and remove it. Be patient, it is very precisely assembled.
-
Loosen tripod ring, till it can rotate.
-
Remove tripod ring. Be aware, the is a 90 degree stepping steel ball inside.
-
-
-
-
Rotate the rear half of the lens, towards close-up direction (CW as looking downwards), pass 8m/25 feet mark and continue, while applying gentle force pulling rear part up, until they separate, mark the point.
-
When assemble them back, attach from this angle/point.
-
-
-
This is just a partial tear down. This lens is extremely well made, and very very precise.
-
Until this point, this is a reasonable "maintenance teardown". And you can do most mirror and lens cleaning and grease replace.
-
Putting them back from the point/angle you marked in previous step, the focus scale does not need a calibration.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annuleren: ik heb deze handleiding niet afgemaakt.
4 andere personen hebben deze handleiding voltooid.
2 opmerkingen
I am looking for more understanding of this breakdown. I have questions about the fragility of the components and how to clean the interior of the front glass of mold spores. Additionally i would love to understand how to calibrate its focus. Can you advise?
This is a professional lens, built very tough. Primary mirror cleaning is quite easy. but front element is kind of tricky. because there’s an inner thread there covered by damping oil/grease. Maybe you should try remove it from the front. remove the filter/cap thread ring first(My cap used to stuck with this ring so I‘ve got this far)…
In step 3, there are 2+3 screw holes at each end , those are for focus ring stopping screws. 3 for inf end and 2 for close end (if my memory is correct). But this is for adjustment instead of “calibration“. By my guess a giant lens like this could never be calibrated due to the TCE of aluminium tube. that’s why the focus ring is allow to go beyond inf.
Terrance -