Gereedschappen die in deze demontage worden gebruikt

Deze demontage is geen reparatiehandleiding. Om je Pentax Optio WG-1 GPS te repareren, gebruik onze reparatiehandleidingen.

  1. Clean the device. You are able to rinse with under running water. It is recommended to ensure that you remove the battery and memory card before working with the device.
    • Clean the device. You are able to rinse with under running water. It is recommended to ensure that you remove the battery and memory card before working with the device.

    • Prepare a clean workstation and have your tool(s) ready.

    Voeg opmerking toe

  2. Remove 4 Phillips 1/4 inch 00 screws around the border of the display with the screwdriver.
    • Remove 4 Phillips 1/4 inch 00 screws around the border of the display with the screwdriver.

    Voeg opmerking toe

    • Remove the black rubber adhesive around the border of the device by peeling slowly.

    Voeg opmerking toe

    • Remove 2 Phillips 00 1/4 inch rubber sealed screws off the top of the camera.

    Voeg opmerking toe

    • Remove the display screen from the casing. When opening, the micro USB cover and the battery cover will fall out with a pin.

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • Remove all orange strips located on the motherboard and the LCD screen.

    • Lift black latches before removing the strips.

    Voeg opmerking toe

    • Remove the lens from the camera carefully. It is the black block held inside the casing.

    Voeg opmerking toe

    • Remove 3 Phillips 00 screws from the motherboard.

    Voeg opmerking toe

    • Remove 2 Phillips 00 screws from the mini USB bay.

    Voeg opmerking toe

    • Remove 2 Phillips 00 screws from the silver handle on the side of the camera.

    Voeg opmerking toe

    • Remove 3 Phillips 00 screws from the camera's photo capture button.

    • After removing those screws, remove the plastic piece and buttons they secure.

    Voeg opmerking toe

    • Remove 3 Phillips 00 screws from the same location located under the cameras photo capture button.

    Voeg opmerking toe

    • Remove the motherboard from the housing.

    Voeg opmerking toe

Brandon Berlew

Lid sinds: 27-01-15

122 Reputatie

1 Handleiding geschreven

Team

Pasco Hernando, Team 1-3, Prince Winter 2015 Lid van Pasco Hernando, Team 1-3, Prince Winter 2015

PHSC-PRINCE-W15S1G3

6 Leden

1 handleiding geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 6

Afgelopen 30 Dagen: 22

Altijd: 2,241