Gereedschappen die in deze demontage worden gebruikt

Deze demontage is geen reparatiehandleiding. Om je Morphy Richards Iron te repareren, gebruik onze reparatiehandleidingen.

  1. This is the iron we will take apart.
    • This is the iron we will take apart.

    Voeg opmerking toe

  2. First remove the rear or the iron using the flathead screwdriver.
    • First remove the rear or the iron using the flathead screwdriver.

    Voeg opmerking toe

    • Next remove the cable bridge bracket.

    Voeg opmerking toe

    • Next remove the screws from the base. (see arrows for location)

    Voeg opmerking toe

    • Next remove the screw the hold the top on.

    Voeg opmerking toe

    • To free the long cable remove from terminal block at rear.

    Voeg opmerking toe

    • At the front of the iron pull out the buttons for the steam and water.

    Voeg opmerking toe

    • Next unclip the button holder (red circle) by undoing the screws (black circle)

    Voeg opmerking toe

  3. Gratis verzending op bestellingen van meer dan $20
    Gebruik code BLUEANDBLACK bij het afrekenen
    Gratis verzending op bestellingen van meer dan $20
    Gebruik code BLUEANDBLACK
    • Next remove the bridge clip from the arrows position.

    Voeg opmerking toe

    • Next remove the inner button (black circle)

    • Now remove the centre screw (red arrow)

    Voeg opmerking toe

    • slide off the cable holder from the cable.

    Voeg opmerking toe

    • Disassemble the plug

    • First remove the casing.

    • Now remove the wires from the pins.

    • Next remove the pins.

    Voeg opmerking toe

    • Remove front of the iron by undoing the screw (arrow) by first taking off cover cap.

    Voeg opmerking toe

    • Next take out round selector, this is simply clipped so can be pulled out with pliers.

    Voeg opmerking toe

    • Next remove the washer parts at the front of the iron.

    • Take the tubing off.

    من فضلكم كيفة افك الجزءالامامي من الحديد

    douahiahmed - Antwoord

    • Remove the seals for the water pump.

    • Now take pumps out.

    Voeg opmerking toe

    • Remove the screw (circled) this will lead to the separation of the base and the top.

    Voeg opmerking toe

    • Remove the top of the iron to reveal the under parts.

    • Now remove the rubber seals from the plate.

    • Take out the screws linking to the stainless steel base.

    Voeg opmerking toe

    • Remove the terminal block from the wires.

    • Next take off the black section of the iron.

    Voeg opmerking toe

    • Now remove the screws from the steel base.

    Voeg opmerking toe

    • Next remove each individual part ( mostly wiring)

    i need THERMASTER wher shell i get

    KRISHNA NANA MOHITE - Antwoord

    • All parts at the end of the process.

    Voeg opmerking toe

RIchard fox

Lid sinds: 17-03-10

260 Reputatie

1 Handleiding geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 6

Afgelopen 7 Dagen: 40

Afgelopen 30 Dagen: 230

Altijd: 20,007