Gereedschappen die in deze demontage worden gebruikt

Deze demontage is geen reparatiehandleiding. Om je Acer Liquid E1 te repareren, gebruik onze reparatiehandleidingen.

  1. Remove the plastic back and the exposed battery.
    • Remove the plastic back and the exposed battery.

    • Do not forget to remove sim- and SD-cards

    • Use a torx t5 to unscrew all screws. This will be the first and last time you'll use a screwdriver with this device.

    Voeg opmerking toe

  2. Use a plastic opening tool or spudger
    • Use a plastic opening tool or spudger

    • Pry around the side to release the backframe from the middleframe

    • Be careful as the frame is quite fragile

    Voeg opmerking toe

    • To free the main board, remove the connector and antenna-cable

    • Use a plastic spudger

    • Be careful not to chip components

    Voeg opmerking toe

    • Tilting the main board will reveal this connection

    • Use a plastic spudger to open the lock

    • Carefully pull the flex cable out of it

    • Don't put alot of stress on it

    Voeg opmerking toe

  3. Gratis verzending op bestellingen van meer dan $20
    Gebruik code BLUEANDBLACK bij het afrekenen
    Gratis verzending op bestellingen van meer dan $20
    Gebruik code BLUEANDBLACK
    • At the bottom, use a pair of tweezers to remove the yellow tape from the connector

    • Use a plastic spudger to unlock

    • Pull the flexcable out carefully

    Voeg opmerking toe

    • Next, use a platic spudger to remove the flex cable from its connection

    Voeg opmerking toe

    • Use a spudger to remove the bottom-plate from the frame.

    • Be careful when using metal tools (like I did)

    • Make sure the antenna cable isn't attached to anything except it's socket

    Voeg opmerking toe

    • Let the remaining heat at 95°C for about 3-5 minutes to soften the adhesive

    • Use an opening tool to pry at the top, between your digitizer and the middleframe

    • Open it from the top, your digitizer-flex runs at the bottom

    • Be careful when using a heat-gun. Heat-guns don't distribute heat evenly and LCD-burns may occur

    Voeg opmerking toe

    • To remove the LCD, remove the sticker on the back of the midframe. It conseals the LCD-flex

    • Be careful when removing the sticker. It's glued tightly and too much stress will tear the LCD-flex

    • Remove the LCD by pulling the whole cable through the midframe.

    Voeg opmerking toe

    • All done

    • I hope you enjoyed it as much as I did

    Voeg opmerking toe

Maxim

Lid sinds: 30-04-14

2.201 Reputatie

3 handleidingen geschreven

Team

iFixers Belgium Lid van iFixers Belgium

Business

1 Lid

3 handleidingen geschreven

Één commentaar

Great Manual.. it work fine! thanks,,

qwertykeyboard.404 - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 5

Afgelopen 30 Dagen: 21

Altijd: 5,054