iPad mini & mini 2 Adhesive Strips

  • iPad mini & mini 2 Adhesive Strips
iPad mini & mini 2 Adhesive Strips

US$ 6,99

US$ 6,99

We zullen een bericht sturen als het product weer op voorraad is.

Productdetails

Beschrijving

Beschrijving

Use these custom cut adhesive strips to fix a loose front panel or to close the case after another internal repair. These adhesive strips are compatible with a 1st or 2nd generation iPad mini.

Individual pieces fit precisely around important components and provide a sturdy closure.

Notitie

Due to continuing improvements, actual product may differ slightly from photo.

Compatibiliteit

iPad Mini 2 LTE
128 GB
16 GB
32 GB
64 GB
iPad Mini 2 Wi-Fi
128 GB
16 GB
32 GB
64 GB
iPad Mini CDMA
16 GB
32 GB
64 GB
iPad Mini GSM
16 GB
32 GB
64 GB
iPad Mini Wi-Fi
16 GB
32 GB
64 GB

Toon 2 meer apparaten

Reparatieverhalen

Olaf Berg's Story Photo #1195984

Mijn probleem

I needed to change the battery on my Ipad mini.

I tried several times with a hairdryer to loosen the glue without any luck.

I then ordered the Fixit opener from US, and it arrived i my postbox in Norway after one week.

Mijn oplossing

I heated the opener in my microwave and following the instruction I managed to ope . . .

Mijn probleem

Initially a broken iPad screen but in the replacement process I damaged the LCD screen so that had to be replaced as well.

Mijn oplossing

Working through the repair guide for the screen replacement was straight forward. And the second time thru it when I replaced the LCD was even easier and I took my time and doub . . .

Mijn probleem

The battery had developed bad cells and wouldn't hold a charge for more than a minute or so. The iPad mini was otherwise intact so it made sense to try and replace the battery.

Mijn oplossing

There was a time after removing the LCD that the instructions weren't super clear about separating the LCD from some tape (b . . .

Mijn probleem

iPad Mini LCD was only showing a white line with no picture, but the hardware could be seen by the computer.

Mijn oplossing

Repair took a long time and was tedious...The iOpener pack was not getting hot enough to loosen the glue so i had to repeat the softening process several times, besides that the repair went we . . .

Mijn probleem

ipad went into the water during a boat race. would boot but screen was grayed out

Mijn oplossing

many small pieces and screws, otherwise ok

Mijn advies

.

Geef meer weer