Repareer je spullen Gemeenschap Winkel

GE A1050 LCD Replacement

Terug naar de handleiding
Engels
Nederlands
Stap 3
GE A1050 LCD Replacement: stap 0, afbeelding 1 van 3 GE A1050 LCD Replacement: stap 0, afbeelding 2 van 3 GE A1050 LCD Replacement: stap 0, afbeelding 3 van 3

  • Do not remove the back side of the case, just flip it over. The speaker is connected by wires to the main body, but positioned in the back case.

  • Flip the LCD to the bottom. You can not yet remove it, because it is still attached to the board.

  • The LCD cable is held into the connector via some compression clips. Move both ends carefully away from the connector, toward the LCD.

  • The clips only move about an 1/8 of an inch. Be careful not to use too much force.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.